Global

‡ In these countries please contact our distributor

VERILAST Technology for Hips

Product Information


What is VERILAST Technology for Hips?

VERILAST Technology is a combination of our proprietary OXINIUM heads and a highly cross-linked polyethylene (XLPE) liner.

 

What are the features of VERILAST?

As an orthopaedic surgeon, you have a variety of options when choosing a hip implant best suited to your patients. However, you also deal with an unfortunate list of tradeoffs with most bearing couples. Then there's VERILAST Technology for Hips. The coupling of OXINIUM material on XLPE is the only technology that eliminates the concerns faced with other bearing combinations.


• No risk of ceramic type fracture, chipping or squeaking
• Biocompatible solution for metal sensitive patients
• Less polyethylene wear debris compared to standard cobalt chrome heads

Combine Smith & Nephew XLPE with the R3 acetabular shell designed specifically to protect for XLPE with:
• Flush seating liners to reduce impingement chances and increase ROM.
• Axial locking mechanism located lower in the shell where the poly is thicker and stresses can be distributed better.
• Ultracongruent shell to fully support the poly for better stress distribution.
• Large antirotation tabs for rotational stability.

Download the VERILAST for Hips Messaging Brochure

Click here for more information on R3 Acetabular System

For more information about OXINIUM and how it is made, click here.

Clinical Evidence


VERILAST Clinical Evidence

The Australian Orthopaedic Association National Joint Replacement Registry has published its results for 2011 and VERILAST continues to distinguish itself from all other bearing surfaces.
There are two key takeaways from the latest report:  
1. The Ceramicised Metal/ Modified Polyethylene category represents only Smith & Nephew VERILAST bearings.
 
2. The VERILAST Ceramicised Metal/ Modified Polyethylene has the highest survivorship (97.8%) of all bearing categories at 7 years.

 

Download VERILAST results

Design


VERILAST Hips Design Information

A biocompatible solution for metal sensitive patients.
• OXINIUM heads contain no detectable Nickel, Cobalt, or Chromium which are the most allergen causing metal elements for humans.

A reduced risk of osteolytic potential.
• Due to its lubricious nature, OXINIUM will wear like a ceramic head.
• OXINIUM on XLPE has been shown to produce fewer polyethylene particles than CoCr on XLPE even under active conditions.
• Less wear particles means less ostyletic potential.

Smith & Nephew's XLPE for Hips = 10 MRad irradiated 1050 polyethylene
• Fully supported poly.
• Mechanical strength less critical.
• Higher radiation dose = improved bearing wear.

What is an OXINIUM femoral head?
• OXINIUM is made from Zirconium with 2.5% Niobium metal alloy.
• Under special heating conditions it grabs oxygen from the environment.
• Oxygen mixes with Zirconium to form Zirconium Dioxide.
• Zirconium Dioxide is a true monoclinic (no phase change) ceramic.
• OXINIUM has a ceramic surface that is integral to the underlying metal.
• The ceramic is not a coating. It can bend and flex with the metal.
• OXINIUM is known as a functionally graded material meaning it starts as one
material and under special conditions transforms to a different material.
• The ceramic surface is 5-7 microns thick with an underlying hard material known as the oxygen enriched zone. Below this is the Zirconium-Niobium alloy.